Silencer Adapter DonnyFL FX Crown/Royal/Boss/Bobcat

Do you have an FX Crown, Royal, Boss or Bobcat and want to fit a silencer to it? With this DonnyFL FX adapter you get a 1/2 UNF connection on which you screw a silencer to reduce shot noise. The adapter is CNC-machined from aluminium and features a matte black anodising layer. If there's no silencer fitted, a knurled knob keeps the thread neatly protected — a practical solution for those who use their FX seriously.

How to install the DonnyFL FX 1/2 UNF silencer adapter:
Pay close attention to the installation: only with correct placement will the barrel shroud stay in place and not shift.

• You'll need fine-tipped tools — a needle-nose pliers or snap ring pliers — thin enough to fit into the two holes of the cap at the front of the barrel.
• Hold the barrel shroud with one hand, carefully place the plier tips in the holes of the cap and turn counter-clockwise (anticlockwise). The barrel shroud should now come loose easily; once it moves smoothly, unscrew the cap further by hand.
• Next, remove the barrel shroud so you can secure it via the guide underneath and prevent it from shifting after screwing on a silencer.
• Use a 2.5 mm allen key to loosen the clamping screw of that underlying guide. At the rear you'll see a locating pin that aligns with a hole in the rear cap.
• Slide the guide backwards, let the locating pin drop neatly into the hole and tighten the clamping screw again.
• Finally, replace the barrel shroud and screw the DonnyFL FX adapter into place.